Energy UNITS FOR LIFT TABLE one
Basic Description
This energy unit is designed exclusively for the compact lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit is broadly applied inside the marketplace of logistic devices like minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled from the solenoid valve with the pace controlled from the 
adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is built solely for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the pace managed through the adjustable needle valve. Once the lift rises to a high positoin, however the energy supply is cut, the decreasing motion is controlled from the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is created solely to the large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the pace controlled by a stress compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is made solely for the substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the pace managed from the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is minimize, the decreasing motion is managed through the manual override function.
Unique Notes
1. This power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all of the hydraulic elements concerned in advance of set up of the power unit.
3. Viscosity of the oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities.N46 hydraulic oil is encouraged.
4. Oil changing is required after the original 100 operation hrs,afterwards after every single 3000 hours.
five. The energy unit proven is built to be mounted vertically.
