one.A connecting link of an O-ring Chain for general application is pre-coated with grease at the pins. Before connection, verify the grease over the surfaces of pins, and if your quantity of grease is small, apply grease with bare hands. (If gloves are used, the grease will likely be absorbed by the gloves.)
Example: When the connecting link (I) of an O-ring chain for general application is
shipped, O-rings are fitted in the roots with the pins. If your O-rings come loose because of vibration in the course of transport, refit the O-rings in on the roots from the pins.
In this instance, make sure to return the grease collected on the roots of the pins for the central surfaces of the pins, much more at portion A than at portions B shown inside the above illustration. (Portions A is worn as a result of sliding using the bushings.)
2.The chain might be most simply linked on the teeth of a sprocket. Engage the hyperlinks at each ends with the chain with the sprocket teeth and fit connecting pins. In case the sprocket might be moved, the chain can also be connected to the loosened side.
three. Connecting method
1.Confirm that O-rings are attached towards the roots from the pins.
2.If the quantity of grease utilized on the connecting pins is small, coat the pins 
with grease in the central portions.
3.Insert the connecting pins into the bushings of the inner backlinks at both ends.
four.Verify that the grease is applied for the whole face in the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins into the connecting plate and while pressing the connecting plate, install the spring clip. Verify no matter if the head (the finish with no split) of your spring clip is turned while in the feeding course from the chain. (See the next illustration.)
6.Make sure to confirm the spring clip is securely fitted inside the clip grooves of your connecting pins.
This completes jointing on the connecting website link. Note that grease over the surfaces of connecting pins and O-rings is often removed in the course of installation get the job done. In this instance, re-grease using the grease within the surface of the base chain or even the grease during the polyethylene bag during which the connecting website link was contained.
