SMR Gearbox Installation
Satisfactory effectiveness depends upon suitable set up. lubrication and maintenance. consequently it is important the guidelines from the set up and servicing leaflet. 
provided with each and every gearbox. are followed very carefully. some of the crucial elements of belt and torque-arm set up are listed under.
one. Install pulley on gearbox input shaft as shut to the reducer achievable, and mount reducer on driven shaft as close to bearing as practical. failure to perform this can cause extra loads from the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive with all the belt pull at somewhere around 90° on the center line among driven and input shafts. this will likely permit tensioning from the wedge belt drive together with the torque arm which must ideally be in stress. if output hub runs anti-clockwise. torque arm must be positioned the right.
three. lnstall torque-arm fulcrum on the rigid help so that the torque-arm will be at around ideal angles towards the center line through the driven shaft and the torque arm case bolt. ensure that there may be adequate take up within the turnbuckle for belt stress adjustment.
Hold close.
Bell drive might be found in any handy postion. in the event the torque arm is usually to be employed to tighten the belts, the drive need to be at about tight angle to the line between the input and output shafts.
Bell drive may be located on the suitable if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven in the illustration.
Torque arm and belt take up.
Torque arm may be mounted to the proper if sought after.
